The MSI RTX 5090 GPU hardware fault, can potentially melt the connector. This is a known issue with the 12V-2×6 standard. Why is this important?
Safeguard+ monitoring detects zero current on pin 2 before connector melting occurs
Because uneven current loads can lead to high-end GPU hardware failure, even before anything becomes apparent. So make sure you're keeping a close eye on the power delivery, otherwise you may end up with permanent hardware failure.
This issue was discovered when someone got an RMA'd replacement MSI RTX 5090 card. It was plugged into an MSI AI1300TS power supply. This power supply includes Safeguard+ monitoring software. This means you can check in real-time what's going on with the power pins at idle and low load.
What Safeguard+ noticed was no current on pin 2 from the 12V-2×6 connector, it alerted to this immediately. They noticed that the GPU connector port is slightly lifted. A manufacturing fault. This creates uneven loads on the pins of the connector.
This problem demonstrates the possibility of connector melting due to uneven current load on RTX 50 series GPU. The person is going to RMA the 2nd card to avoid any chance of connector failure (if the card was running at full load). We've been following RTX 5090 a lot, also covered MSI RTX 5090 Gaming Trio Sold.
So this here is confirmation that there is a hardware fault with the MSI RTX 5090 that was caught using power supply monitoring. It's not a software fault. It's an uneven pin load from what we can see here that looks to be a physical manufacturing fault. So if you have this card, you should make sure you're seated right and keep an eye out for any anomalies with the power delivery.



Comments (0)